C. assembly procedure, C. assembly procedure -4 – Sharp AL-1651CS Benutzerhandbuch

Seite 43

Advertising
background image

AL-1651CS DISASSEMBLY AND ASSEMBLY 8 - 4

8) Move the carriage to the position indicated on the figure.

9) Loosen the screw which is fixing the tension plate.

10) Move the tension plate in the arrow direction to release the ten-

sion, and remove the belt.

11) Remove the screw, and remove the rod stopper.

12) Remove the rod.

13) Lift the rear side of the carriage, remove the belt and the connec-

tor, and remove the carriage.

C. Assembly procedure

CCD core

1) Pass the core through the CCD-MCU harness.

2) Insert the CCD-MCU harness into the CCD PWB connector of the

carriage unit.

3) Move the core which was passed through the CCD-MCU harness

near the CCD PWB connector as shown in the figure below, and fix
it with a filament tape (19mm wide, 40mm long). For the attach-
ment reference, refer to the figure below. Clean and remove oil
from the attachment section.

4) Attach the CCD-MCU harness to the duplex tape on the back of

the carriage unit.

5) Attach the PWB holder to the position specified in the figure below.

6) Pass the core through the FFC and the PWB holder, and fix the

core.

1)

2)

4)

3)

1)

2)

3)

1)

2)

4)

3)

Note: Attach the FCC to the base
plate securely with duplex tape
to prevent against coming loose.

Note: Attach the FCC to
fit with the marking line.

Marking line.

Advertising