Sharp AL-1651CS - Handbuch (Seite 77)

AL-1651CS TEST COMMAND, TROUBLE CODES 10 - 7
9 01 Duplex motor normal
rotation check (DPLX ROT.) [Function]
Use the duplex motor Bios to drive the duplex motor in the normal direction (paper exit direction) for
30sec.
After completion of this process, the machine goes into the sub code entry standby mode.
[Operation]
02 Duplex motor reverse
rotation check (DPLX
ROT.REV.) [Function]
Use the duplex motor Bios to drive the duplex motor in the reverse direction for 30sec.
After completion of this process, the machine goes into the sub code entry standby mode.
[Operation]
10 00 Toner motor operation
(TONER MOTOR) [Function]
When [ENTER/START] key is pressed, the toner motor is rotated for 30sec.
After completion of this process, the machine goes into the main code entry standby mode.
[Operation]
14 00 Cancel of trouble other than
U2 (TRBL CANC.) [Function]
Used to cancel troubles other than U2.
∗ Cancel troubles such as H trouble which writes data into EEPROM, and perform hardware reset.
[Operation]
16 00 U2 trouble cancel (U2 TRBL
CANC.) [Function]
Used to cancel U2 trouble.
When [ENTER/START] key is pressed, check sum of the total counter in the EEPROM is rewritten
and hardware reset is made.
[Operation]
22 04 JAM total counter display
(JAM TTL CNT) [Function]
The JAM total counter is displayed.
[Operation]
05 Total counter display (TTL
CNT) [Function]
The total counter value is displayed.
[Operation]
08 SPF counter display (SPF
CNT) [Function]
The SPF counter is displayed.
[Operation]
Main
code Sub
code
Contents Details of function/operation
1) Initial display
09-01 DPLX ROT.
EXECUTING...
1) Initial display
09-02 DPLX ROT.REV.
EXECUTING...
1) Initial display
10-00 TONER MOTOR
EXECUTING...
1) Initial display
14-00 TRBL CANC.
CLEARED
1) Initial display
16-00 U2 TRBL CANC.
CLEARED
1) Initial display
22-04 JAM TTL CNT
***,***
1) Initial display
22-05 TTL CNT
***,***
1) Initial display
22-08 SPF CNT
***,***