Sony RM-VL900T - Handbuch (Seite 41)

41 GB
6
Press ENT (ENTER) on the
sending remote
Commander.
As the data is received, the
corresponding Component
Select buttons light up one by
one.
If data transfer has been
unsuccessful during or after
the procedure, the S (set)
indicator and all Component
Select buttons flash five times,
and the Commander returns to
its state in Step 5. Either try
again from Step 6, or press S
(set) to cancel data receival.
Note
If you do not perform Step 6 within 10
seconds, the S (set) indicator and all
Component Select buttons flash five
times, followed by a short pause, and
then flash again.
3
While holding cursor V
pressed, press the Number
1 button.
The S (set) indicator flashes
and all Component Select
buttons light up.
4
Confirm that the sending
remote commander is ready
for data transfer.
(To set the sending
commander, follow the
procedure on page 38.)
Note
Be sure that the sending remote
commander is ready to transfer
data.
5
Press ENT.
The S (set) indicator lights up
and all Component Select
buttons turn off (data-reception
standby).
Continued