Sony SIR-3400H - Handbuch (Seite 106)

15-10
(E) SIR-3400H / SIR-3032i / SIR-3032W
15. Data Recording/Playback
15-5-2. Recording and Playback AUX Analog Data
Connecting the AUX Analog Signals
1
Set the IRIG timecode to Off. (See section 8-2-6.)
2
Use a BNC cable (sold separately) to connect the AUX-2 (IRIG-B) IN connector on the rear panel and
the AUX analog data signal from the AUX analog signal source.
If necessary, use a BNC cable (sold separately) to connect the AUX-2 (IRIG-B) OUT connector on the
rear panel and monitoring equipment.
When the AUX analog data signal is input, the input state is displayed in the status display area of the
LCD screen in the mode each of E-E, REC, REC-PAUSE. If it is not displayed, check the cable
connections.
c
. The AUX analog signal is AGC-controlled.
. The rated input level of AUX analog data signals is ± 2 Vpk.
The maximum input level is approximately
±3 Vpk.
Recording AUX Analog Data Signal
When recording starts, the AUX analog data signal input to the AUX analog channel is recorded on the
recording media simultaneously along the main data signals.
Playing Back AUX Analog Data Signal
When a recording media recorded with an AUX analog data signal is played back, the AUX analog data
signal is output from the AUX-2 (IRIG-B) OUT connector on the rear panel.
Analog signal source
Monitoring equipment