Sony SIR-3400H - Handbuch (Seite 6)

(2)
(E) SIR-3400H / SIR-3032i / SIR-3032W
Installation
WARNING
. When unpacking, packing or installing, assign more than 2 persons to handle the unit to prevent injury.
. Be careful never to drop the unit when handling, unboxed or boxed. If the unit is dropped, turn the power
OFF and unplug the unit and call service engineer person to check it before using again.
. Be sure that the unit is firmly positioned on its supporting surface. The unit cause an injury if it falls or
dropped.
. To allow adequate air circulation, do not block the ventilation of the unit.
. Do not place the unit or other heavy objects on the power cord. If damaged, the cord may cause fire or
electric shock.
Operating Cautions
* Be sure to observe the following cautions.
. Use the supplied power cord.
The POWER cord contains a safety earth ground. Make
sure to connect this earth ground. Failure to do so may
result in electric shock or fire.
Make sure to ground
the POWER cable firmly.
Earth
CAUTION
. Keep the unit away from strong magnetic fields such as high voltage transformers, speakers, and
electric motors.
. When receives strong outer noises, the unit may operate improperly.
. Do not locate the unit in a dusty, hot or humid place.
. Do not place heavy objects on the top of the unit, otherwise it may fall and cause an injury.
. To disconnect the power cord or signal cable, always pull it by the plug. Pulling wire may cause it to be
damaged resulting fire or electric shock.
. Keep the power cord or signal cable away from where people might step on it or trip over it.
. Be sure that the attached AC power cord is firmly connected.
There is a protective ground wire in attached AC power cord.
Operation
WARNING
. Be sure operate the unit only with the specified power supply. Use of an incorrect voltage will
cause severe damage.
. Be sure to input to the unit only the specified signal voltage.
. Replace only with specified type and rated fuse.
CAUTION
. Disconnect the power cord from the unit if it is not in use.
. Disconnect the power cord before replaceing fuse.