Sony SIR-3400H - Handbuch (Seite 64)

8-2
(E) SIR-3400H / SIR-3032i / SIR-3032W
8-2. Settings
8-2-1. Selecting the Frequency Type (Freq-Type)
Factory setting: 48 kHz series
* For the setting procedure, see “8-1. Setting Procedure (for Function Screen)”.
Setting value: 48 kHz series
8-2-2. Recording Media Auto Repeat On/Off (Auto-Repeat)
c
The recording media auto repeat function can be used only on a media on which nothing is recorded.
Use a media after formatted.
Factory setting: Off
* For the setting procedure, see “8-1. Setting Procedure (for Function Screen)”.
<When set to On>
When the end of the recording media is reached during recording, it automatically returns to the start and
continues recording.
During recording, overwriting is performed regardless of the overwrite setting of the recording media.
Although the data that was overwritten is lost, the remaining data and rewritten data can be played back.
<When set to Off>
Recording and playback automatically stop when the recording media reaches the end.
8-2-3. Recording Media Overwrite On/Off (Overwrite)
Factory setting: Off
* For the setting procedure, see “8-1. Setting Procedure (for Function Screen)”.
<When set to On>
The recording can be overwritten.
When you attempt to overwrite, a message “Overwrite?” will appear on the LCD screen. Be sure to check if
the old data is needed. If it is not needed, press the FWD key while holding down the REC key again to start
overwriting.
c
If a portion of the data is overwritten, the data after the current recording point can no longer be played.
<When set to Off>
The recording cannot be overwritten.
8. Function Setup (Function Screen)