Operation settings (using setting key), 1. id number increments, 2. index number increments – Sony SIR-3400H Benutzerhandbuch
Seite 73: 3. setting the recording/playback speed
(E)
12-1
SIR-3400H / SIR-3032i / SIR-3032W
12. Operation Settings (Using Setting Key)
If using Telnet to make settings, refer to the procedure in “17. Control by Telnet”.
For the transport settings, refer to “5. Description of Transport Mode”.
The operation settings are saved by the internal backup battery even when the power is turned off.
In the procedures below, the parentheses in the section title indicates the transport mode where the setting can be
made.
12-1. ID Number Increments
(Mode: REC)
An ID number is automatically assigned to each recording block.
Each time that the SHIFT key is pressed and then INDEX/ID key is pressed during REC mode, the ID
number on the LCD screen increases by one.
Setting value: 1 to 999
The ID number can be used for searches.
12-2. Index Number Increments
(Mode: REC)
Each time that the INDEX/ID key is pressed during REC mode, the INDEX number on the LCD screen
increases by one.
Setting value: 1 to 99 (The index number automatically increase by 1 up to 99 and then go back to 1.)
The INDEX number can be used for searches.
12-3. Setting the Recording/Playback Speed
(Mode: STOP)
The recording/playback speed that was set is applied immediately after the setting is made.
1
Press the SPD/BCM key.
The lamp at the top left of the key and the LCD screen speed indicator flash.
2
Use the f / F key to select the speed.
Some speeds may not be available depending on the number of channels used.
Setting value
x
x
x
x
x4
x
x
x
x
x2
x
x
x
x
x1
x
x
x
x
x1/2
x
x
x
x
x1/4
x
x
x
x
x1/8
x
x
x
x
x1/16
Speed
4
x
2
x
1
x
1/2
x
1/4
x
1/8
x
1/16
MByte/s
12
6
3
1.5
0.75
0.38
0.19
3
Press the SPD/BCM key.
The recording/playback speed is set.