Sony SIR-3400H - Handbuch (Seite 97)

(E)
15-1 SIR-3400H / SIR-3032i / SIR-3032W
15. Data Recording/Playback
Be sure to check the settings before starting recording.
15-1. Data Recording
1
Insert two cartridges in the same recording state.
When the HDD is recognized normally, the recording media access lamp is lit green. When an error
occurred with the HDD, the recording media error lamp is lit or blinks red.
c
If the two cartridges are not in the same recording state, the system switches to media maintenance
mode.
2
Press the REC key.
This enters E-E mode. The input signal can be monitored on the LCD screen without recording data on
the recording media. Also, the signal can be output from the monitor output connector and OUTPUT
connectors.
3
Recheck the settings for the input format, recording/playback speed, number of channels, input range,
input DC offset, and other parameters (see section 4-6).
4
Press the REC key and FWD key at the same time.
This enters recording mode.
n
. In the recording unit default settings, Overwrite is set to OFF. When Overwrite is set to OFF, data is
recorded in the blank space regardless of the media position.
. The ID number increments each time recording starts, and a new ID number is assigned for the next
recording. In addition, a start ID is also attached each time recording starts to allow start ID search.
The INDEX number increments each time the INDEX/ID key is pressed during recording. The INDEX
numbers can be used to find specific locations.
MONITOR
UP DN
1
1
1