Sony GRAND WEGA KDF-50E2000 - Handbuch (Seite 26)

26 GB
Manual Programme
Preset Before selecting “Label”/“AFT”/“Audio Filter”/“Skip”/“Decoder”, press
F
/
f
to
select the programme number you want to modify. Then, press .
System / Channel
Presets programme channels manually.
1
Press
F
/
f
to select “System”, then press .
2 Press
F
/
f
to select one of the following TV broadcast systems, then
press
G
.
B/G: For western European countries/regions
D/K: For eastern European countries/regions
L: For France
I: For the United Kingdom
Note
Depending on the country/region selected for “ Country ” (page 5), this option may not be
available.
3 Press
F
/
f
to select “Channel”, then press .
4 Press
F
/
f
to select “S” (for cable channels) or “C” (for terrestrial
channels), then press
g
.
5 Tune the channels as follows:
If you do not know the channel number (frequency)
Press
F
/
f
to search for the next available channel. When a channel has been found,
the search will stop. To continue searching, press
F
/
f
.
If you know the channel number (frequency)
Press the number buttons to enter the channel number of the broadcast you want or
your VCR channel number.
6 Press to jump to “Confirm”, then press .
7 Press
f
to select “OK”, then press .
Repeat the procedure above to preset other channels manually.
Label
Assigns a name of your choice, up to five letters or numbers, to the selected channel.
This name will be displayed briefly on the screen when the channel is selected.
AFT
Allows you to fine-tune the selected programme number manually if you feel that a
slight tuning adjustment will improve the picture quality.
You can adjust the fine tuning over a range of -15 to +15. When “On” is selected, the
fine tuning is performed automatically.
Audio Filter
Improves the sound for individual channels in the case of distortion in mono
broadcasts. Sometimes a non-standard broadcast signal can cause sound distortion or
intermittent sound muting when watching mono programmes.
If you do not experience any sound distortion, we recommend that you leave this
option set to the factory setting “Off”.
Notes
• You cannot receive stereo or dual sound when “Low” or “High” is selected.
• “Audio Filter” is not available when “System” is set to “L”.