Hochiki TCH-B100 - Handbuch

2-3-0-237/ISS5/AUG09
HOCHIKI TCH-B100 – ESP DEVICE PROGRAMMER
OPERATING INSTRUCTIONS
General Description
The TCH-B100 ESP Programmer is designed for use with the following products:
ALG-E / ALG-EN C Analogue Photoelectric Sensors CHQ-BS 2 Base Sounder
AIE-E
C Analogue Ionisation Sensor CHQ-WS
C Wall Sounder
ATG-E
C
Analogue Heat Sensor CHQ-WS2
C
Wall Sounder
ACB-E
C
/ ACB-EW
2 Analogue Multi-Heat Sensors CHQ-WSB
C Wall Sounder Beacon
ACA-E
C
Analogue Multi-Sensor YBO-BS
C
Base Sounder
ALK-E
C
Analogue Photoelectric Sensor YBO-BSB
C
Base Sounder Beacon
HCP Range
3 Analogue Manual Call Points CHQ-AB
C Analogue Beacon
CHQ-POM
3
Powered Output Module CHQ-SIM
3
Single Input Module
CHQ-ARI
C Analogue Remote Indicator
C = device clips straight onto Programmer, 2 = in conjunction with PL-2 Programming Lead, 3 = in conjunction with PL-3 Programming Lead
The programmer is used to set the address of the above products for use with Hochiki ESP systems. The unit
is designed to be light, robust and easy to use and operates from a single PP3 size, heavy-duty battery which
gives the capacity for up to 8,000 operations.
Keys
The TCH-B100 has 3 operating keys, a middle red key and lower left and right grey keys, these keys have the
following functions.
‰ Left (grey key) key - Power On - automatically reads the address of the fitted sensor - subsequent
operations of this key will advance the programmer address in units of 10.
‰ Right (grey key) key - Advances the programmer address display in units of 1. Also used as the Power Off
button.
‰ Middle (red key) key - Stores the displayed address to the Sensor and is used to read the Sensor’s
analogue levels.
Operation - Address Setting
‰ Locate the Device onto the programmer ensuring the 3 locating pips line up with the grooves in the
programmer.
‰ Press the left (grey) key to switch the programmer on, a battery check message will be displayed followed
by the address of the device fitted (previously un-programmed devices will read 127).
‰ Select the required address by incrementing the programmer display (left grey key, 10’s, right grey key,
units). Whilst the display is showing an address different to that stored in the device, 3 dots will also flash.
‰ Once the wanted address is displayed press the upper (red) key to store the address in the device. Once
the address is correctly stored the 3 dots will cease to flash and the display will show the address set.
‰ To program a CHQ-BS a PL-2 Programming Lead must be used, firstly connect the plug into the remote
programming socket on the TCH-B100 and then connect the black croc clip to the C terminal, and the red