Festo Привод со шпинделем DGE-SP - Handbuch (Seite 29)

Eliminating faults
Fault Possible cause Remedy
Uneven movement of
slide No lubrication Lubricate (see chapter Maintenance)
Restrictors incorrectly
inserted If possible, restrict exhaust
Dirt on guides Clean, provide cover
Guide damaged Return for repairs, inform Festo
Slide strikes too hard
against end stops Not enough cushioning Increase end position cushioning (e.g.
with shock absorbers)
Delay too small/too late Change delay (e.g. by adapting drive
control/positioning of the proximity
switch)
Speed too high Reduce speed
Work load too large Reduce work load
Slide vibrates with
long strokes Speed too high Reduce speed
Work load too large Reduce work load
Not enough supports Use centre supports
Other interference Defect on integrated
linear drive See operating instructions for the
integrated linear drive
Fig. 46
10
9709a D/GB 29