Fcc information (u.s.a.) – Yamaha Portatone PSR-400 Benutzerhandbuch

Seite 45

Achtung! Der Text in diesem Dokument wurde automatisch erkannt. Um das ursprüngliche Dokument anzeigen, können Sie den "ursprünglichen Modus" verwenden können.

Advertising
background image

i

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets FCC require­
ments. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use
the product.

2. IMPORTANT:

When connecting this product to accessories and/or another product use only high quality

shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions. Failure

to follow instructions could void your FCC authorization to use this product in the USA.

3. NOTE:

This product has been tested and found to comply with the requirements listed in FCC Regulations, Part

15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance

that your use of this product in a residential environment will not result in harmful interference with other elec­
tronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to

the instructions found in the users manual, may cause interference harmful to the operation of other elec­
tronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all
Installations. If this product is found to be the source of interference, which can be determined by turning the

unit “OFF" and “ON", please try to eliminate the problem by using one of the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon

lead, change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer authorized

to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corpo­

ration of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its

subsidiaries.

171

Advertising