Melissa 741-048 - Handbuch (Seite 20)

20 2 20 2
Tip!
• Always stand the appliance upright
when taking a break from ironing!
• Always check the ironing
instructions in the clothes before
commencing ironing. Always follow
the instructions.
• Start with clothes that require the
lowest temperature and turn up the
heat as required.
• Always iron synthetic fabrics
and silk on the reverse side. This
prevents shiny spots on the fabric.
• Wool products (00% wool) can be
pressed when the appliance is set
to steam mode. We recommend
using the setting for maximum
steam (d.), with a layer of dry fabric
between the iron and the item to
ironed.
Auto shut-off
To increase safety, the appliance
is equipped with an auto shut-off
function. The thermostat automatically
switches the heat off after 0 seconds
if the appliance is lying motionless flat
on its soleplate, and after 8 minutes if
standing upright on its end.
Once auto shut-off is activated, the
indicator light (9) flashes and the
appliance beeps five times.
• Lift or move the appliance to stop
the auto shut-off function, or reset
the thermostat by turning the
thermostat button to MIN, and
then to the desired temperature.
• The indicator lamp will go out
and the thermostat lamp will
light. Continue ironing once the
thermostat light goes out again.
After ironing
• Remove the plug from the socket.
• Empty the water reservoir.
• Reconnect to the mains, place
appliance upright and let the sole
dry until the thermostat lamp goes
out.
• Allow to cool completely and dry
the sole with a damp cloth.
• Always store upright, and place a
cloth over the sole for protection.
CLEANING
General cleaning
• The appliance must not be
immersed in water or any other
liquid.
• Clean appliance (with the
exception of the sole) using a
damp cloth and a little detergent if
necessary.
• Never use a scouring sponge
or abrasive cleaning agents for
cleaning the soleplate. Use a well-
wrung cloth and warm water.
• The spray nozzle can be cleaned
using a needle.
Automatic cleaning function
The appliance has an automatic
cleaning function, and we recommend
its use every 4 days (possibly more
frequently if using very hard water) as
follows:
• Disconnect from the mains (if
connected).
• Fill the water reservoir to MAX,
(see 'Filling with water'), and close
the water reservoir cover.
• Turn the thermostat button to •••,
and push the function selector to
b.
• Stand the appliance upright,
connect to mains and switch on
the power.
• Wait until the thermostat light goes
out. Hold the appliance horizontally
over a sink and push the function
selector to the cleaning position
(a.). Press hard, as the button can
be stiff, and keep your finger on
the button.
• Hot water and steam will now run
out of the holes in the soleplate,
and any calcium deposits and
impurities will be washed out.
Shake the appliance gently
from side to side until the water
reservoir is empty.
• Release the function selector as
soon as the water reservoir is
empty.
• Repeat the cleaning procedure
if large quantities of calcium
deposits were washed out.
• Remove the plug from the socket.
• Place the appliance on top of
an old tea towel or similar to dry
before putting it away.
INFORMATION ON DISPOSAL AND
RECYCLING OF THIS PRODUCT
Please note that this Adexi product
is marked with this symbol:
This means that this product must not
be disposed of together with ordinary
household waste, as electrical and
electronic waste must be disposed of
separately.