ION TTUSB - Handbuch (Seite 3)

ION TTUSB Owner's Manual V9.1 - Page 3
GENERAL CONTROLS
1. Power Cable: This power
cable should be plugged
into a wall receptacle
AFTER all audio
connections are made.
2. RCA Audio Output
Cables: These cables
should be plugged into the
audio inputs of your home
stereo system. (Please
note: you can still copy
records to your computer,
even if the audio outputs of
the turntable are not
connected to a stereo
system).
IMPORTANT: There is a
switch on the bottom panel,
next to the RCA cables, that
selects between
PHONO/LINE. Use PHONO
level for plugging into a
turntable input on a home
stereo. Use the LINE level
for plugging into
CD/AUX/TAPE inputs.
WARNING: You may damage your receiver if you plug in a LINE level into
a PHONO input.
3. USB Audio Output: Use the included USB Cable to connect your turntable to
your computer. For transferring your vinyl records to your computer, we have
provided two different software packages on the included CD. EZ Vinyl / Tape
Converter or EZ Audio Converter is the easiest and quickest way to transfer
your vinyl records and should be used if you are a beginner. Alternatively, if you
are an advanced user you may wish to install and use the Audacity software,
which allows you to take advantage of advanced audio editing features, such as
audio normalization, noise removal and automatic track separation.
4. Power Button: Turns the unit on and off.
5. Platter: This platter must be securely fastened to the turntable prior to
operation. The Motor Drive Belt can be found on the drive ring underneath the
platter. See SETUP INSTRUCTIONS for detailed information on installing the
Motor Drive Belt.
6. Start/Stop Buttons: These buttons start and stop the turntable motor. Both
buttons have the same function. If they seem to not be functioning, check to
make sure that the Motor Drive Belt is properly installed in the SETUP
INSTRUCTIONS.