Jabra LITEMOUNT LP425 - Handbuch (Seite 8)

A t t a c h t h e M o u n t i n g P l a t e t o t h e P r o j e c t o r
6
Attach the Mounting Plate to the Projector
1 Set the projector on a table with the bottom
side up.
CAUTION: Use only the
hardware that is provided
with the LP 425 Ceiling
Mount. Using different
hardware may damage
your projector.
2 Insert the 2 screws into the 2 quick release
sleeves.
3 Loosely attach the screws and sleeves to the
holes in the projector as shown in Figure 3.
4 Align the keyholes in the mounting bracket
with the screws in the projector. Slide the
mounting bracket until the quick release
sleeves are at the top of the keyhole slot.
5 Attach the 8 mm knurled knob to the projec-
tor in the location shown in Figure 3. Tighten
the two 8 mm screws and the 8 mm knurled
knob. Be careful not to over-tighten the
screws.
F IGURE 3
Attach the mounting plate to the projector
quick release sleeves
knurled knob
goes here