Kompernass PSBM 1100 - Handbuch (Seite 7)

9 GB/IE
Preparing for first use / Operation
Preparing for first use
Attaching the auxiliary handle
For reasons of safety, this device must be used
only with the auxiliary handle
8 in place and
properly attached.
It is essential that you note the following:
if the drill becomes jammed, a very large torque
can be generated („the force that the machine will
exert to rotate about its own shaft“).
j Attach the auxiliary handle 8 to the spindle
collar and fix in place by tightening the wing
screw. Attach the depth stop
10 . This will help
you to drill to the exact depth required.
Inserting a tool into the chuck
Caution! Before starting any tasks on the hammer
drill, make sure that it is switched off and the
mains plug is out of the socket.
The RÖHM quick-release drill chuck allows you to
exchange drills or other tools without using a
special key etc.
Opening the chuck and
inserting a tool
j Hold the rear shell of the quick-release chuck 9
and turn the front shell until the tool (e.g. a
roundshanked drill) can be inserted. Insert
the tool.
Tightening the chuck on
to the tool
j Hold the rear shell of the quick-release chuck 9
and turn the front shell sharply until you hear
a „click – clack, clack, clack“ sound (refer to
Figure A). The chuck is now locked. To release
the lock again, just turn the front shell in the
opposite direction.
Using the tool as a driver
j You will require a suitable bit holder if you wish
to use screwdriver bits with the drill.
The screwdriver bits used must be match the
screw head. Set the switch
1 a to the drill
symbol.
Operation
Figures B - H show the various possible applications
and uses.
Examples of applications and uses. Drill bits not
included.
The mains voltage at the mains socket must match
that shown on the rating plate on the device.
Devices marked with 230 V can also be operated
at 220 V.
Switching on and off
Switch on intermittent operation mode:
j Press the On / Off switch 3 .
Switch off intermittent operation mode:
j Release the On / Off switch 3 .
Switch on constant operation mode:
j Press the On / Off switch 3 , and keep it
pressed, then press the locking button 4 .
Switch off constant operation mode:
j Press the On / Off switch 3 and release it.
Infinitely adjustable
speed setting
To produce a slow speed, just press lightly on the
On / Off switch
3 . This allows you to start up your
operations smoothly and in a controlled manner.
If you increase the pressure on the On / Off switch
3 , the speed will also increase.