Kompernass KH 1605 - Handbuch (Seite 5)

- 3 -
Technical data
Mains voltage: 230-240 V ~ 50Hz
Power consumption : 150 W
Protection class:
II /
Recommended operating times:
Vacuuming:
15 Seconds
Sealing: 5 Seconds
After vacuuming and sealing allow a break of
80 seconds before continuing to seal further bags.
Description of the appliance
q Cutter
w Protection strip over the sealing wire
e Cover - film compartment
r Extractor supports
t Sealing wire
y Control lamp
u Appliance cover
i Unlocking device right
o Button
a Unlocking device left
s Bag around the exhaust supports
d Lug under the exhaust supports
f Clip on the filter box
g Seal on the filter box
h Selector switch
j Clip on the filter cover
k Lock for exhaust supports
Commissioning
➩
Place the appliance on a non-slip and stable
surface.
➩
Insert the power plug into a wall power socket.
Inserting the film
➩
Open up the cover to the film compartment e
and insert a roll of tube film.
➩
Pull a piece of the film out and close the cover of
the film compartment
e .
Utilisation
Cutting the film
➩
Pull out as much film as is required for the moment.
➩
Slide the cutter q all the way to the left.
➩
Lay the pulled out film smoothly over the cover
to the film compartment
e and pull the film to
the rear.
➩
Fixate the film above and below the cutter q
with your fingers.
Note:
Press simultaneously on the two unlocking devices
left
a and right i and open up the appliance cover
u . In this way you can better fixate the film when
cutting.
IB_KH1605_E2247_LB3 25.01.2008 12:53 Uhr Seite 3