Kompernass PTKS 1800 SE - Handbuch (Seite 11)

13 GB/IE/CY
Operation
CAUTION: Be sure to fix / secure the
saw blade
4 again after each change
of angle setting.
Q
Switching on and off
The table saw has a soft start system.
This produces a short
delay when the ma-
chine starts.
To switch on:
j
Press the green switch I of the ON / OFF
switch
16 .
Switching off the device:
j
Press the green switch 0 of the ON / OFF
switch
16 .
Emergency switch off:
j Press the cover of the ON / OFF switch 16
closed.
Unlocking the ON / OFF switch cover:
j Slide the emergency knob upwards and flip
the ON / OFF cover upwards.
Q
Attaching the guide fence
Attach the guide fence 1 by hooking it
on to both sides of the saw table 5
and pressing the handle downwards.
“HIgH” setting (see Fig. N):
j Attach the guide fence attachment 1a with its
broader side to the guide fence 1 .
Set the desired cutting width on the centimetre
scale “High”.
“LOW” setting (see Fig. N):
j
Attach the guide fence attachment 1a with the
narrower side to the guide fence 1 .
Set the desired cutting width on the centimetre
scale “Low”.
Q Attaching the mitre guide
Note: Use the mitre guide 8 only when fully in-
stalled (with the guide rails). Slide the mitre guide
8 from the front into the groove 6 in the saw
table 5 . The angle can be set to ± 60° by loosen-
ing the mitre guide handle 8c .
Angle stop:
With the three stops
8a you can set at angles of
± 90° / ± 45° using the angle stop 8d (see Fig. L).
Q
Sawing
Straight cut:
j
First set the required blade height.
j
You can set the inclination angle if required.
j
Attach the guide fence 1 .
j Sawing a long workpiece (≥ 2.5 m) needs
careful planning in advance. Work on long
workpieces should be carried out together with
a second person who is experienced and
knows how to use the saw. This person is there
to hold and support the workpiece. Ensure that
the second person is also wearing all the rec-
ommended protective clothing.
j Switch on the machine as described above.
j Push the workpiece evenly in the direction of
the saw blade
4 (see Fig. F). Saw the work-
piece in one complete sawing operation.
Use the push stick
12 if the distance between
the guide fence 1 and the saw blade 4 is
≤ 120mm.
j Switch off the machine immediately if you are
not going to continue to use it.
Mitred cuts:
j
Set the required blade height.
j
You can set the angle if required.
j
Attach the mitre guide.
j
First slide the mitre guide 8 into the groove 6 .
j
Loosen the handle of the mitre guide using the
clamping screw 8c , set the desired angle and
retighten the handle of the mitre guide using
the clamping screw
8c .
j
Press the workpiece against the mitre guide 8 .
j
Switch on the machine as described above.