Pet 23 vario, Kh 3145, Type 53 – Kompernass Parkside PET 23 Benutzerhandbuch

Seite 5: Type 55, Type 47, Technical information, General safety advice for electrical power tools, Workplace safety

Advertising
background image

7

GB/IE/CY

Introduction / General safety advice for electrical power tools

Q

Technical information

nominal voltage:

230 V ~ 50 Hz

Impact cycles:

30 / min

Short-term
operation time (KB):

max. 15 min

Protection class:

II /

Noise and vibration data:
The sound pressure level (A-weighted) of the
device is typically 95,0 dB(A). The sound level while
working can exceed 108,0 dB (A).

Wear ear protection!

Evaluated acceleration, typical:
Hand / arm vibration a

h

= 5,54 m / s

2

WARNING!

The vibration level given in these

instructions has been measured in accordance with
a standardised measurement procedure and can
be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. In some cir-
cumstances it is easy to underestimate the vibration
load if the electrical power tool is used regularly.

Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.

PET 23 VARIO

KH 3145

230 V ˜ 50 Hz

Date of manufacture: 04-2008
Kompernaß GmbH · 44867 Bochum (Germany)
www.kompernass.com

30 /min

Type 53

12 - 18 mm

KB

max.

15 min

Type 55

12 - 19 mm

Type 47

23 mm

ID:0

0000222

32

General safety advice for

electrical power tools

WARNING!

Read all the safety advice

and instructions!
Failure to observe the safety advice and instructions
may result in electric shock, fire and / or serious injury.

KEEP ALL THE SAFETY ADVICE AnD InSTRUCTIonS
In A SAFE PLACE FoR FUTURE REFEREnCE!

1.

Workplace safety

a)

Keep your working area clean and
well lit.
Untidy or poorly lit working areas
can lead to accidents.

b)

Do not work with the device
in potentially explosive envi-
ronments in which there are

inflammable liquids, gases or dusts.

PET23_ELECTRIC STAPLE GUN_Content_LB3.indd 7

25.04.2008 9:18:06 Uhr

Advertising