Linksys SRW224G4P - Manual (Page 56)

Chapter  Configuring the Switch
2 24-Port 10/100 + 4-Port Ggabt Swtch wth WebVew and Power over Ethernet
Admin > Cable Test
Admin > Cable Test
To test the connection quality of an attached cable, click
on the Test button for the port .
NOTE: The cable needs to be connected at both
ends, otherwise the test will fail .
The cable test results for each port are displayed in the
table .
Admin > Ping
You can use a ping to see if another site on the network
can be reached . Ping sends ICMP echo request packets to
another node on the network .
Admin > Ping
Enter the IP address or host name of the device you want
to ping, then click Go . The ping results are displayed in the
Ping Status text box .
The following are some commonly displayed results of a
ping:
Normal response The normal response occurs in one
to ten seconds, depending on network traffic .
Destnaton does not respond If the host does not
respond, a “timeout” appears in ten seconds .
Destnaton unreachable The gateway for
this destination indicates that the destination is
unreachable .
Network or host unreachable The gateway found
no corresponding entry in the route table .
Admin > Save Configuration
Admin > Save Configuration
Downloads or uploads Switch configuration files from a
TFTP server . The Switch allows the start-up configuration
to be saved or restored from a TFTP server . You must
specify Upgrade to download a new configuration file or
Backup to save a configuration file to the server .
Select the Upgrade or Backup option . Enter the IP address
of the TFTP server, specify the name of the configuration
file on the server, and then click Save Settngs .
•
•
•
•