Ac power features – Peavey Nitrobass Benutzerhandbuch

Seite 4

Advertising
background image

AC POWER FEATURES:

1.

REMOVABLE AC POWER CORD
This receptacle is for the IEC line cord (included), which provides AC power to the unit.
Connect the line cord to this connector and to a properly grounded AC supply. Damage to
the equipment may occur if an improper line voltage is used. (See voltage marking on unit.)
Never remove or cut the ground pin of the line cord plug. This unit is supplied with a properly
rated line cord. When lost or damaged, replace this cord with one of the proper ratings.

NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the
colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which
is colored green and yellow must be connected to the terminal which is marked by the letter
E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored
blue must be connected to the terminal which is marked with the letter N, or the color black.
(3) The wire which is colored brown must be connected to the terminal which is marked with
the letter L or color red.

2.

POWER SWITCH
This switch is used to turn the NitroBass on or off. To turn the unit on, flip the switch to the
“on” position.

3.

GROUND POLARITY SWITCH
Three-position, rocker-type switch, which for most applications should be operated in the
center (zero) position. If hum or noise is present with the ground switch in the center position,
place the ground polarity switch to positive or negative (+ or -) to minimize hum; should a
problem continue, consult your authorized Peavey dealer, the Peavey factory, or a qualified
service technician. Note: The ground switch is not available on 220/240 volt models.

4.

FUSE

The fuse is located within the fuse holder on the rear of the unit. If the fuse should fail, IT
MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID
DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY
. If the amp
repeatedly blows fuses, it should be taken to a qualified service center for repair.

4

REAR PANEL

2

4

1

3

Advertising