Parkside PWS 125 A1 - Handbuch (Seite 16)

16 GB/IE
© Other accessories
You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
M14
Speed: min. 12000 rpm
Backing plate for grinding discs
Dimensions:
ø 115 mm / 125 mm
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
ø 115 mm / 125 mm
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
ø 75 - 100 mm
Speed: min. 12000 rpm
Cup brush, twisted wire
Dimensions: ø
75 mm
Speed: min. 12000 rpm
Cup brush, knotted wire
Dimensions: ø
115 mm
Speed: min. 12000 rpm
© Adjusting the disc guard cover
½
WARNING!
DANGER OF INJURY!
Pull the mains plug out of the mains socket
before you carry out any task on the device.
DANGER OF INJURY! Always use the an-
gle grinder with the disc guard cover 5 in
place. The disc guard cover must be securely
attached to the angle grinder. To ensure the
highest level of safety while using the device,
ensure that the smallest possible area of the
grinding or cutting tool is exposed to the oper-
ator at all times (see Fig. B, C). The disc guard
cover
5 is there to protect the operator from
pieces breaking off and accidental contact
with the grinding or cutting tool. The disc guard
cover has 5 set positions.
˽
Turn the disc guard cover 5 into the desired
position (working position). The closed side of
the disc guard cover
5 must always be facing
the operator.
Use of accessories