Princeton AGX700 - Handbuch (Seite 11)

11
No tools are required to install the AGX700. Simply follow the
instructions outlined in the next few pages.
Connect the female end of the power cable to the power input
receptacle on the back panel of the AGX700. Then plug the male end of
the power cable into an AC outlet.
Attach the loose end of the signal cable to the display adapter. Be
cautious in inserting the cable properly into the display adapter. If the
cable does not seem to fit it may be facing the wrong direction. Turn the
cable over and try to match the shape of the connector with that of the
display adapter.
Switch ON the power to both the AGX700 and your computer. There will
be a short delay before the display appears.
Adjust the controls, if necessary, to obtain the best display. Instructions
on how to use the On-Screen Display controls and the Auto Setup button
may be found in the next chapter, “Controls and Functions.”
Adjust the tilt and swivel base for your maximum viewing comfort. The
illustrations below illustrate the adjustment range for tilt and swivel.
To minimize eye fatigue, we suggest you allow a minimum
viewing distance of 18 inches.