Yamaha P-85/85S - Handbuch (Seite 24)

Recording Your Performance
P-85 Owner’s Manual
ENGLISH
24
4.
Press either [REC] or [PLAY] button to stop record-
ing.
When recording is stopped, the [REC] lamp and the [PLAY] lamp flash to indi-
cate that the recorded data is being saved to the instrument automatically. After
the data is saved, the
[REC] lamp will turn off and the [PLAY] lamp will light.
CAUTION
Do not turn off the power of the instrument when the lamps are flashing. Doing so
may prevent saving of the song data which you have recorded.
Play back the recorded performance
Press the [PLAY] button to play back the recorded performance. To stop playback in the middle of a
song, press the [PLAY] button again.
While holding down the [METRONOME] button, use the TEMPO [ g g g g ]/[ h h h h ] but-
tons to change the playback tempo.
Both the [REC] lamp and the
[PLAY] lamp will begin to flash
when the recorder memory is
almost full. If the memory
becomes full, recording will stop
automatically. (All recorded data
up to that point will be retained.)
You can save the recorded data
to a computer. You can also load
the recorded data back from a
computer and play it back on this
instrument (page 27).
NOTE
NOTE
The user song recorder records the following data:
Data in addition to the notes and voices you play is recorded.
• Notes played
• Voice selection
• Pedal (Sustain/Soft/Sostenuto)
• Reverb depth
• Dual mode voices
• Dual balance
• Dual octave shift
• Tempo
• Reverb type (including OFF)
Pressing the [REC] button to start
recording, then pressing the
[PLAY] button to stop recording
will erase all previously- recorded
data.
You cannot re-record in the mid-
dle of a song.
NOTE
NOTE
22