Velleman VMBIRTS - Handbuch (Seite 4)

4
Open the battery compartment at the back (remove both screws) and insert two AAA batteries. Mind the polarity.
The display will show a brief animation if the batteries are correctly inserted.
BATTERY
SETTING UP THE UNIT
Example with the VMB4PD 'Push button and Timer panel' :
Address setup:
To be able to control your VMB4PD Push button and Timer panel, you have to make sure the address of your VMB4PD
matches the Remote Stick address.
Look up the address of your VMB4PD (check the VMB4PD manual for how-to instructions). Remember the last digit of the address
(e.g. if the address is 'A3', remember '3').
Next, press and hold SW2 of the Remote Stick (located in the upper left hand corner) until the display shows '3'. Release the
button. The display will blink and turn off. The correct address is now stored in memory.
Remark : Even with the batteries removed, the unit will remember the selected address.
Number of channels and skip-channel selection :
Default, the unit allows you to scroll trough 4 channels: 1, 2, 3, 4 (hold unit upright to enable channel selection).
To change the number of accessible channels (i.e. to be able to control the second page of your VMB4PD) or to
automatically skip unused channels:
Press SW2 repeatedly to select the required channel.
Press SW1 repeatedly to toggle between 'include channel' (decimal point lit) or 'exclude channel' (decimal point not lit).
To exit, select 'E' with SW2 and press SW1 to exit.