VEGA T32.10-11-30 - Handbuch (Seite 4)

GB
2383336 12/2008 GB/D
 WIKA Operating Instructions Temperature Transmitter T32.10/11/30
1. General information / 2. Safety instructions
1. General information
WIKA temperature transmitters are carefully designed and manufac-
tured using state-of-the-art technology. Every component under-
goes strict quality inspection before assembly and each instrument
is fully tested prior to shipment.
Note
Please inspect the equipment for possible damage during trans-
portation. Should there be any obvious damage, please inform the
Transport Company and WIKA without delay.
The following installation and operating instructions have been
compiled by us with great care but it is not feasible to take all possi-
ble applications into consideration.
If questions remain regarding a specific application, you can obtain
further information (data sheets, instructions, etc.) via our Internet
address (www.wika.de / www.wika.com / download) or contact
WIKA for additional technical support. (see section 1, Service).
2. Safety instructions
When mounting, starting and operating these transmit-
ters it is important to observe the respective national
safety precautions and regulations in effect (e.g. VDE
100). Serious injuries and/or damage can occur should
the relevant regulations not be observed.
Only qualified persons authorised by the plant manager are
permitted to install and service these transmitters. When working on
the terminals of the T32.10 while the process is running it is recom-
mended to take appropriate measures to avoid any electrostatic
discharge, because discharges may result in temporary falsifica-
tions of the measured value.