Velleman 951 - Handbuch (Seite 2)

951 VELLEMAN 2
OPERATING MANUAL 951
ULTRASONIC DETECTOR
INSTALLATION
Install the two sensors, one to each upper corner of the front windscreen or rear window. The
sensors must face straight down the sides of the vehicle. This provides maximum coverage. Do not
face them diagonally inwards. Truk the clips under the windscreen surround and ensure that are
tightly fixed so that their orientation will not change. Mount them high enough in order to keep the
ultrasonic wave's path from being obstructed by objects such as high seats of headrests.
NOTE : The receiver/transmitter wires may not be shortened or lengthened, other than using the
supplied extension pieces, and always ensure that the wires are not pinched or torn during
installation! The extensions are provided so that a connection point for the sensors are under the
dash, to make replacement of the eyes easier if this is necessary. Never cut the sensor wiring!
NOTE :
- The sensors are designed to pick up any movement inside the car, and this includes the movement
of air. Always make sure all windows, sunroof and air vents are firmly closed, and that there are
no hanging ornament!
- Do not mounted the sensors on the areas where temperature may get very high due to direct
sunlight. Sensitivity of the detector may cause false triggers!
- Do not aim the detector directly at windows! False triggers will result due to normal vibration of
windows from loud trucks, motorcycles or high winds.
WIRING
A. BLACK WIRE
Connect to vehicle chassis ground.
B. RED WIRE
Connect to constant +12 volts power source.
C. WHITE WIRE
Connect to the alarm system ground trigger input terminal or wires. For alarm's providing a separate
negative grounding pin switch, this is the idea input to use.
TESTING
1. Using a small, flat-blade screwdriver, rotate the sensitivity adjustment to "-" position.
- Turn to the mark "-" position decreases sensitivity.
- Turn to the mark "+" position increases sensitivity.
2. Close all doors and leave a window open sufficiently to allow your arm to pass through.
3. Arm the alarm as usual, put your arm through the window.
4. If the ALARM doesn't sounds after your arm through the window, rotating the adjustment knob
1/8 turn to "+" position for increasing sensitivity.
5. Repeat steps 3 and 4 until the alarm sounding.
Note :
Don't turn sensitivity up so that gentle knocking on vehicle window will not cause alarm to
be triggered.