AEG S41540TSW1 - Handbuch (Seite 12)

Problem Possible cause Solution
The temperature in
the appliance is too
high. The temperature regula-
tor is not set correctly. Set a lower temperature.
The door is not closed
correctly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room
temperature before stor-
age.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigerator is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is
cold air circulation in the
appliance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
There is too much
frost. Food is not wrapped cor-
rectly. Wrap the food correctly.
The door is not closed
correctly. Refer to "Closing the
door".
The temperature regula-
tor is not set correctly. Set a higher temperature.
8.1 Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover (refer to the
illustration).
4. Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
12 www.aeg.com