AEG S41600TSW0 - Handbuch (Seite 31)

Installing under a continuous worktop
If your refrigerator is installed under a continuous
worktop, an air outlet opening of at least 200cm
2
and a ventilation grille matching the worktop de-
sign should be installed at the rear of the work-
top.
The cut surfaces of the worktop should be var-
nished to avoid swelling due to penetration of
moisture.
The appliance wall distance must be at least 30
mm and should be checked before the ventilation
grille is inserted.
Detaching the worktop
To remove the worktop, please proceed as follows:
1. Unscrew left and right screws at the back.
2. Lift the worktop slightly at the front, push
back about 20 mm and lift off from the front.
3. Unscrew left and right screws at the front.
4. Store the screws in a safe place together with
the worktop.
Fitting and mounting to continuous worktop
Before fitting, change the door opening direction
if necessary (see: Door reversibility).
Push the appliance carefully into the niche.
Take care that the mains cable is not jammed in.
Check distance from wall (see: Installing under a
continuous worktop).
Level the appliance by screwing the two adjusta-
ble feet at the front in or out, thus ensuring a sta-
ble position.
With a suitable screws (depending on the design
of the worktop and the distance between the appliance and the worktop, not supplied), fix
the appliance under the worktop through the upper door hinge. If necessary, equalise the
gap between the door hinge and the worktop with a suitable washer (plastic or wood, not
supplied). This will prevent bending of the hinge and possible failure of door function.
500/550/600
105
570
550 93-103
2
200 cm
820 min
A
1
2
3 3
4
2
Installation 31