Zanussi ZTB261 - Handbuch (Seite 8)

Door opening and laundry
loading
1. Open the door.
2. Load your laundry (do
not force it in).
Caution! Do not jam
laundry in between
the loading door and rubber
seal.
3. Close loading door se-
curely. Lock must au-
dibly lock.
Selecting the programme
Turn the programme selec-
tor dial to the required pro-
gramme. The light START
PAUSE starts to flash.
Selecting additional functions
You can choose from the additional functions:
button 1 -DELICATE
button 2 -TEXTILE
DELICATE
Pressing this button allows drying to be performed at a
lower temperature, for delicate items. The corresponding
pilot light comes on. This option can also be used for time
controlled drying.
TEXTILE
Press the Textile button repeatedly, to select the desired
option. The relevant light will light up. You can select 2
different options: COTTONS cycle: to be used for cot-
ton, and SYNTHETICS : to be used for synthetic or
delicate items.
Starting the programme
Press the START PAUSE button. The programme is
started.
The programme phase is shown by appropriate lights;
light 6- DRYING
, light 5- END .
Changing programme
To change a programme which has been selected by mis-
take once the programme has started, first turn the pro-
gramme selector to "O" -OFF position. The programme
is cancelled.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob or if an function button (excluding the
BUZZER button
2) ) is pressed, led on the START PAUSE
button starts flashing temporarily in red. The drying
programme is not however affected by this (laundry pro-
tection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the lights END and
light 4- FILTER are on. If the buzzer is active, an
acoustic signal sounds intermittently for about one mi-
nute.
The drying cycles are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This keeps
the laundry loose and free of creases. The laundry can be
removed at any time during the anti-crease phase. (The
laundry should be taken out towards the end of the anti-
crease phase at the latest to prevent creases from form-
ing.)
1. Open door.
2. Remove laundry.
3. Remove filter after clothes has been removed. Clean
the filter.
Warning! Before You place the filter , please check
it there is nothing inside the filter seat.
4. Turn the programme selector to -OFF.
Important! Clean the filter after each drying cycle.
5. Close the door.
2) Only dryers with buzzer button
8