Xoro HRS 8580 - Handbuch (Seite 58)

17
First steps
Channel Search
After all connections have been made properly, switch on TV and make sure the receiver is connected to the Main
Power. Press Power button to switch receiver on.
If you are using the receiver for the first time or restoring to
Factory Default, the Main Menu will appear on your TV
screen.
1. OSD
Language
2. Load pre-programmed channels
Navigate with the arrow keys CH+ and CH- or VOL- and
VOL+. OK activates an option and EXIT leaves a setup
menu.
NOTE: The default password is “000000”.
OSD Language
Choose a language.
Load pre-programmed channels
If you select Yes, the receiver will load the pre-programmed channels into the channel list. Otherwise, you will get the
Dist Setup menu.
Dish SETUP
Before beginning the setup you should get straight about
your satellite system. There are many different options.
The menu is structured in a satellite list (Left) and further
options (Right).
1. Simple connection of satellite and receiver (from page 18)
2. Direct connection of satellite dish and receiver by using Tone burst (from page 20)
3. Using multiple satellites via DiSEqC 1.0 (from page 20)
4. Using multiple satellites via DiSEqC 1.0 and Tone burst (from page 21)
5. Using multiple satellites via DiSEqC 1.1 (from page 21
)
6. Using multiple satellites via DiSEqC 1.2 (from page 22)
7. Using multiple satellites via DiSEqC 1.3 (from page 23)