AEG S72300DSW0 - Handbuch (Seite 41)

1
3
2
Fit the doors into the pins and install the
doors. Install the hinge.
On the opposite site, install the hole cov-
ers.
Tighten the hinge. Make sure that the
doors are aligned.
Remove and install the handle (if fore-
seen) on the opposite side.
Reposition, level the appliance, wait for at
least four hours and then connect it to the
power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The Af-
ter Sales Service specialist will carry out
the reversibility of the doors at your cost.
ELECTRICAL CONNECTION
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
contact for this purpose. If the domestic
power supply socket is not earthed, con-
nect the appliance to a separate earth in
compliance with current regulations, con-
sulting a qualified electrician.
The manufacturer declines all responsibili-
ty if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
ENGLISH
41