AEG SKS71240S0 - Handbuch (Seite 15)

Problem Possible cause Solution
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
The temperature in
the appliance is too
low. The temperature regulator
is not set correctly. Set a higher temperature.
The temperature in
the appliance is too
high. The temperature regulator
is not set correctly. Set a lower temperature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time. Store less products at the
same time.
There is no cold air circula-
tion in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
REPLACING THE LAMP
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp
cover.
3. Remove the lamp cover (refer to
the illustration).
4. Replace the used lamp with a new
lamp of the same power and spe-
cifically designed for household ap-
pliances. (the maximum power is
shown on the lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cov-
er.
7. Connect the mains plug to the
mains socket.
8. Open the door. Make sure that the
lamp comes on.
CLOSING THE DOOR
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
15