Technical data, Installation, Closing the door – AEG S41540TSW0 Benutzerhandbuch
Seite 14: Positioning
3.
Remove the lamp cover (refer to the il-
lustration).
4.
Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover).
5.
Install the lamp cover.
6.
Tighten the screw to the lamp cover.
7.
Connect the mains plug to the mains socket.
8.
Open the door. Make sure that the lamp comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Height
850 mm
Width
550 mm
Depth
612 mm
Rising Time
11 h
Voltage
230 V
Frequency
50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
14
Technical data