AEG KD92903E - Handbuch (Seite 4)

4 Installation instructions
INSTALLATION INSTRUCTIONS
Before installation
Check that the input voltage indicated on the characteristics plate is the same as the
voltage of the power outlet you are going to use.
Open the drawer and take out all the accessories and remove the packing material.
Attention! The front surface of the crockery heater may be wrapped in a protective film.
Before using the crockery warmer for the first time, remove this film carefully.
Make sure that the crockery warmer is not damaged in any way. Check that the drawer
opens and closes correctly. If you find any damage, contact the Technical Assistance
Service.
Attention: the power socket should be easily accessible after the crockery warmer has
been installed.
The crockery warmer should only be built-in in combination with those appliances
indicated by the manufacturer. If it is fitted in combination with other appliances, the
guarantee is no longer valid since it is impossible to guarantee that the crockery warmer
will work correctly.
Installation
To build-in the crockery warmer in combination with another appliance there must be a
fixed, interim shelf in the housing unit to support the weight of both appliances.
The appliance to be combined with the crockery warmer will be placed directly on the
latter without any need to have a separating shelf.
To build-in the appliance which is combined with the crockery warmer, follow the
instructions set out in the respective instructions and fitting booklet.
The relevant installation dimensions are indicated in mm in the diagrams shown at the
end of this booklet. Proceed as follows:
1. Place the crockery warmer on the shelf and
slide it towards the interior of the niche in
such a way that it is centred and
completely lined up with the front of the
unit.
2. Check that the crockery warmer’s frame is
properly levelled and is sitting evenly on the
shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the
provided screws.