WolfVision VZ-C6 User Manual - Handbuch (Seite 12)

If the top light of the Visualizer is used (default) a synchronized lightfield always marks the pick-up area of
the built-in camera on the working surface.
The alignment of this lightfield is made for working on the working surface. Due to the oblique mounting of
the cameras and the light projector of the Visualizer, the lightfield shifts to the upper edge of the pick-up
area when the distance between the Visualizer and the scanned object is decreased (when capturing tall
objects).
This means that the lightfield no longer exactly shows the recorded area. In this case switch off the light of
the Visualizer by pressing the assigned PRESET key (LIGHT) and work with room light.
Synchronized Lightfield
1. The synchronized lightfield on the working surface marks the pick-up area of the built-in camera.
Just place your subject material in the illuminated area.
Please note, the lightfield is slightly bigger than the camera pick-up area due to technical reasons.
2. Select the enlargement required with the ZOOM keys (#38).
3. When the image is out of focus, adjust the sharpness with the FOCUS keys (#35).
Shooting Area On The Working Surface
11
To increase the light intensity on the working area, the Visualizer is equipped with an ambient light.
The ambient light cannot mark the pick-up area exactly.
By default, the ambient light will be switched off when zooming to wide at zoom factor 9x.
The behavior of the Ambient light can be changed in the on-screen menu (see page 18).
Ambient Lightfield
Picture center
15°
public
screen
Synchronized
lightfield