WolfVision EYE-10 User Manual - Handbuch (Seite 5)

#14 ZOOM keys
For zooming in and out. Using the zoom keys also activates
the auto iris. - see page 5; Auto Iris / Manual Iris.
#15 FOCUS keys
When using the manual FOCUS keys, the EYE-10 switches
off the auto focus function.
Using the AF
key switches the auto focus on again.
#16 IRIS keys
When using the manual IRIS-keys, the EYE-10 switches off
the auto iris function. The next time the ZOOM keys are
used the auto iris is switched on again.
#17 WHITE key
When the WHITE key is pressed, the camera performs an
one-push white balance - see page 5
#18 AUTO FOCUS key
Switches the auto focus on and off.
The AF light on the camera indicates, if the AF is activated.
#19 MENU key
Pressing this key for 1 second activates the on-screen
menu (see page 6).
#20 MEMORY keys / SELECT keys (double function)
For saving and recalling images (see page 6) - OR
For navigating through the on-screen menu (see page 6).
#21 POWER key
#22 PRESET keys (programmable settings)
For storing a preset, press one of the PRESET keys for
more than 2 seconds. For recalling a preset, press the
PRESET key quickly - see page 6.
#23 FREEZE key
To capture the current image - see page 5.
#24 LASER POINTER key
Important: do not stare directly into the laser beam.
This is hazardous for youre yes!
WIDE TELE
1 2 3
MEMORY
1
2 3
4
LASER
FOCUS
IRIS
PRESETS
WHITE
AUTO FAR NEAR
FREEZE POWER
MENU
KEYS ON THE EYE-10
4
#15
#17
#18
#19
#14
#16
#22
#24
INFRARED REMOTE CONTROL
Please note that an infrared remote control can only be used up to a
certain distance from the unit. Objects situated between the EYE-10
and the infrared remote control and weak batteries will obstruct the
reception. If the camera can only be controlled from a short distance
with the infrared remote control or if it cannot be controlled at all you
may have to change the batteries.
Open the cover on the back of the remote control by hand and replace
the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
If you want to work with more than one EYE-10 in the same room, the
units should be set to different infrared codes, in order to control them
all individually.
To change the IR code, enter the "Misc. Settings" and set the "IR Code" to A, B, C or
D (code A is default). To change the IR code on the remote control, simultaneously press PRESET 1,
PRESET 2
and ZOOM TELE
ress
PRESET 1, PRESET 2 and ZOOM WIDE
on-screen menu, go to
(#22) (#14) - each time this key combination is used, the code switches from A
to B, C, D ... A ... in the order given. For resetting the remote control to code A simultaneously p
.
front back (open)
-
+
-
+
X X
#21
IRIS
ZOOM
WHITE
FOCUS AF MENU
1
2 3
4
MEMORY
POWER
FREEZE
#14
#16
#15
#18
#19
#20
#21
#23
#17
#23
#20
WIDE TELE
1 2 3
MEMORY
1
2 3
4
LASER
FOCUS
IRIS
PRESETS
WHITE
AUTO FAR NEAR
FREEZE POWER
MENU
#14