WolfVision VZ-C32 User Manual - Handbuch (Seite 8)

A light projector (a) inside the unit projects a
lightfield (g) the same size as the pick-up
area of the built-in camera via the mirror (e)
onto the working surface. The image is
recorded by the camera (b) using the same
path via the mirror (f).
The lenses of the light projector (a) and the
camera (b) are synchronized. Thus the size
of the light field on the working surface
changes when the user changes the zoom
range of the camera.
This scanning and illumination system is a
worldwide patent from WolfVision.
1. Connect the power cable to the unit (#15) and plug it in
2. If you would like to use a control monitor, connect it to
the PREVIEW RGB output (#24)
3. Connect a large viewing monitor or a projector to one of
the outputs of the Visualizer
For choosing the right output mode please see page 14!
4. Turn the main power switch (#12) on the unit to "I".
The power indication LED on the unit is illuminated red
to indicate that power is supplied.
5. Press the POWER key (#40) on the remote control
The Visualizer now runs the “power-on preset” .
Power-on preset:
The automatic setting of zooming to an middle zoom position (pick-up size depends on
mounting height of the Visualizer), focus on the working surface level and the auto iris are
activated. As soon as the Power Indication LED is green and stays illuminated, you can
start working with the Visualizer. The behavior of the unit as soon as power is supplied or
after the POWER key has been pressed can be changed in the unit's on-screen menu (see
page 16).
When the unit is turned on for the first time, the Height Adjustment starts automatically. The
Ceiling Visualizer is pre-set to a distance of 2 m (78.76"). In most installations the
installation height will be different to this, so the following adjustments must be performed:
1. Adjustment of camera and light focus
2. Alignment of lightfield and camera field
NOTE: This is a one time setup, which must only be performed again if the distance
between the Visualizer and table is changed! - more details in the installation manual
a) light projector
b) camera
c) image path
d) light path
e) mirror light
(motorized)
f) mirror camera
g) pickup area /
synchronized
lightfield
f
e a
b
g
c
d
How The Visualizer Works
Basic Preparations
The Unit Is Switched On The First Time
6
EXTERN POWER
MEMORY
1 2 3
4 5 6
7 8 9
HELP
MENU
ENTER