Beyerdynamic MA 206 - Handbuch (Seite 39)

english
39
4.7 Mains connection
The mains cable is fixed and equipped with a ground contact.
5. Setting up
After all connections such as mains, microphone and loudspeakers have been
completed, follow these steps to bring the system up:
1. Turn all volume controls to “0”.
2. Turn on the source equipment.
3. Turn on the MA 212 mixer amplifier with the on/off switch (7).
4. Turn the corresponding volume control half up, with the output level control of
the source equipment turned down. There should be no audible hum. If hum is
heard, check the connections between the sound source and the mixer amplifier.
5. Using the volume control microphone (1) you can adjust the volume of the
individual microphone inputs.
6. Using the volume control master (4) the desired volume in the room is adjusted.
7. The volume of the sound carrier input is adjusted with the volume control (2)
independent of the master volume control.
8. Activate a signal.
9. Slowly turn up the source equipment input gain controls until you begin to hear
the sound source from the loudspeakers connected to the amplifier. If the sound
is clear and undistorted, adjust the system level to the desired listening levels.
10. If you want the ducking function of the microphone inputs 1 and 2, it has to be
activated (refer to chapter “4.1.1 Priority switching”).
6. Trouble Shooting
• The power switch is not switched to the
ON position
• The AC plug is not connected
• The AC power source is defective
• Defective fuse
• Switch the power switch to the ON
position
• Connect the AC plug properly
• Locate and correct the AC mains
problem
• Check and exchange the fuse
• Turn the volume control up
• Locate and correct the short circuit
• Reduce output level of the sound
source (for sound carriers)
• Make sure that the impedance is not
below 4 Ω
• Check the loudspeakers, disconnect
one if necessary
No or distorted sound
No reproduction
Problem Possible Cause Solution
• Volume control is set to “0”
• There is a short circuit on the loudspeaker
output
• Input level is too high
• The loudspeaker impedance is too low
• There is too much loudspeaker load on the
output