Festo DADG-UPF-... Монтаж - Handbuch (Seite 2)

Assembly instructions (en)
726 744 / 2007-11NH
†‡
Adapter kit/Blank plate
DADG-AK-.../DADG-UPF-... Festo AG & Co. KG
Postfach
D-73726 Esslingen
++49/(0)711/347-0
www.festo.com
The kit is intended as an adapter between the rotary indexing table DHTG
and fixed blank plate DADG-UPF-....
Note
To avoid functional faults and increased wear:
• Make sure that the O-rings are greased and are not twisted when fitted.
1. Adapter kit DADG-AK-65
1a. Parts list
aA Screw (1x)
aB Adapter (1x)
DADG-AK-65
aC O-ring (1x)
1b. Assembly
• Place the O-ring aC in the
groove in the adapter aB.
• Position the adapter aB in
the rotary indexing table
DHTG. Make sure that the
claws on the bottom of the
adapter aB grip into the re-
cesses on the DHG.
• Tighten the screw aA
Maintain the tightening
torque
(
! Section 4).
2. Adapter kit DADG-AK-90/-140/-220
2a. Parts list
bA Screw (4x/6x)
bB Adapter (1x)
DADG-AK-…
bC Cylindrical pin (2x)
bD O-ring
(1x)
2b. Assembly
• Place the O-ring bD in the
groove in the adapter bB.
• Position the adapter bB
on the fixed centre part of
the rotary indexing table
DHTG with the cylindrical
pins°bC.
• Tighten the screws bA.
Maintain the tightening
torque
(
! Section 4).
3. Blan plate for fixed plate DADG-UPF-...
3a. Parts list
cA Blank plate (1x)
DADG-UPF-…
cB Cylindrical pin (2x)
cC Scraper
ring (1x)
cD Screw (4x/6x)
3b. Assembly
Processing of the blank plate cA
is only permitted without the
scraper ring cC.
• Place the scraper ring cC in
the groove in the plate cA.
• Positionthe plate cA on the
adapter aB/bB with the cy-
lindrical pins cB.
• Tighten the screws cD.
Maintain the tightening
torque
(
! Section 4).
4. Tightening torques 1)
DADG-AK/-UPF-... 65 90 140 220
aA Screw G1/8 — — —
[Nm] 10
bA Screw — M3x12 M4x20 M5x20
[Nm] 1,2 2,9 5,9
cD Screw M4x12 M4x12 M6x16 M8x16
[Nm] 2,9 2,9 9,9 24
1)
Tolerance for non toleranced tightening torques > 1 Nm: ± 20 %.
aC
aB
cB
cA
aA
cC
cD
cA
cC
cB
aB/bB
cD
bC
bB
bD
bA
bB
bD
bA
bC
bB
cA
aB
aC
aA
aB