Retsch AS 450 control - Handbuch (Seite 15)

Transport, scope of delivery, installation
15
Fig. 1: Removing the transport aids and mounting the sieve plate
• Loosen the two transport aids (TH). (1.)
Insert the sieve plate (ST) and make sure the alignment is correct. (2.)
• Screw the sieve plate on with the three provided screws (RA) to finger
tightness. The necessary torqueis approx. 40 Nm.
Then put the three protective caps (SK) onto the screws and press the
protective caps on securely.
Keep the two transport aids for transport at a later date .
4.7 Using the transport aids again
• Remove the three protective caps (SK)
• Loosen the three screws (RA) in the centre of the sieve plate.
• Lift the sieve plate (ST) off the device.
• Screw the two transport aids (TH) into the corresponding threaded bores.
Pos : 6. 19 /00005 Ü berschrif ten/ 1. 1 Ü bersc hrift en/ 1. 1 Übersc hrift en BD A/ 11 Bedienei nheit ansc hließ en @ 0 \ mod_1229076747940_9. doc @ 5026 @ @ 1
4.8 Connect the control unit
Pos : 6. 20 /00010 Bedi enungsanleit ung en Kapitels ammlungen/ AS450_c ontrol/ 0006 Tr ans port, Liefer umf ang und Aufst ellen /AS450 M odul Bedieneinheit ansc hließ en @ 0\ mod_1229077266034_9. doc @ 5032 @ @ 1
Fig. 2: Connecting the operating unit
• Insert connector C into the 9-pin port B13 on the operating unit.
B13
C
C1
C1
SK
TH
ST
RA