Blomberg TKF 9431 A - Handbuch (Seite 6)

6 EN
C Never unscrew the adjustable feet from
their housings.
Electrical connection
Connect the machine to a grounded outlet
protected by a fuse of suitable capacity as
stated in the technical specifications table. Our
company shall not be liable for any damages
that will arise when the machine is used on a
circuit without grounding.
• Connection must comply with national
regulations.
• If the current value of the fuse or breaker
in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
• Power cable plug must be within easy
reach after installation.
• The voltage and allowed fuse or breaker
protection are specified in the “Technical
Specifications” section.
• The specified voltage must be equal to your
mains voltage.
• Do not make connections via extension
cables or multi-plugs.
• The main fuse and switches must have a
contact distance of minimum 3 mm.
B Damaged power cable must only be
replaced by a qualified electrician.
B If the product is faulty, it must not be
operated unless it is repaired! There is the
risk of electric shock!
First use
• To have the product ready for operation
before calling the authorised service agent,
make sure that its location and power
supply installations are appropriate. If they
are not, call a qualified electrician to have
any necessary arrangements carried out.
• Make sure that the power connections of
the product are in accordance with the
instructions given in relevant chapters of
this manual.
You can directly send the accumulated water
out through the water drain hose supplied with
the machine instead of periodically draining the
water collected in the water tank.
Please refer to the detailed instructions supplied
with the accessories pack.
Connecting the water drain hose;
1. Remove the hose on the machine by pulling
it out from its end. Do not use any tools to
take out the hose.
2. Connect the special drain hose supplied with
the machine to the pipe fitting.
3. The other end of the drain hose can be
directly connected to the wastewater drain
or to the washbasin. The fitting must always
be secured in all types of connections. Your
house may be flooded if the hose gets out of
its housing during water discharge.
Important:
• The hose should be attached to a height of
maximum 100 cm.
• You must be careful not the pinch or bend
the hose.
• The end of the hose should not be bent, it
should not be stepped on and it must not be
folded between the drain and the machine.
Adjusting the feet
In order to ensure that your machine operates
more silently and vibration-free, it must stand
level and balanced on its feet. Balance the
machine by adjusting the feet.
Rotate the feet to adjust until the machine
stands level and firmly.