Clearaudio MAXIMUM SOLUTION - Handbuch (Seite 27)

Maximum Solution
Bedienungsanleitung/USER MANUAL
Seite/Page 27 © clearaudio electronic GmbH 2007
4. SPECIAL INSTRUCTIONS
Please take the time to fill out the enclosed warranty card and return it to Clearaudio or your local
distributor / dealer. This will guarantee you a fully covered warranty on your product.
During any transportation of the turntable, always remove the platter and inverted bearing and put a
security tape on the. If this is not done, DAMAGE COULD OCCUR!
Please regularly check the mains leads of your motor assembly. If there is any damage to any wires
or the mains plug, have them replaced immediately only by a qualified person (your dealer or
distributor).
To clean the turntable, use only special acrylic cleaner, which is not alcohol based. Otherwise you
could damage the material (hair cracks and spots on the acrylic surface).
Keep your clearaudio Maximum Solution turntable out of extreme temperature and extreme
moisture environments.
5. Service
If the platter (without drive belt) does not turn as easy as usual, you should squeeze a up to 5mm
long line of the bearing grease into the upper part of the platter bearing. You will have the same
problem, if there is too much grease inside the bearing.
If any service or repair on all clearaudio products is necessary, please contact your dealer /
distributor or contact clearaudio directly. We will inform you about your nearest service location.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You will need it if this unit has to be transported and/or
shipped.
Extra : Acrylic dust cover for the clearaudio Maximum Solution turntable (item-#: AC028)
Extra : Additional tonearm base with custom cut for all known tonearms (item-#: AC030)
Clearaudio electronic GmbH
Spardorfer Str 150
91054 Erlangen
Germany
Tel/Phon: +49-(0)1805/059595
www.clearaudio.de
[email protected]