Clearaudio CHAMPION MAGNUM - Handbuch (Seite 16)

Champion
Magnum
Bedienungsanleitung
USER MANUAL
Seite/Page 16  clearaudio electronic GmbH 2006
5. Speed calibration
Install the drive belt, first around the platter, then around the motor pulley. There are two diameters on
the motor pulley:
• smaller for 33 1/3 rpm
• larger for 45 rpm
To correctly adjust the belt tension, turn the motor around its axis. Proper tension will be achieved
through eccentric placement of the motor pulley or if you have enough space on your platform, just
change the distance between the motor and the turntable chassis. The belt tension is correct if the belt
can be deflected by approximately ¾inch by a finger.
6. Special Instructions
Please take the time to fill out the enclosed warranty card and return it to clearaudio or your local
distributor / dealer. If you do not return this card within 14 days after purchase the guarantee will
only be for a period of two years from the date of purchase. During any transportation of the
turntable, always remove the platter and inverted bearing. If this is not done, DAMAGE COULD OCCUR!
Please regularly check the mains leads of your motor assembly. If there is any damage to any wires or
the mains plug, have them replaced immediately by a qualified person (your dealer or distributor).
To clean the turntable, use only special acrylic cleaner, which is not alcohol based. Otherwise you
could damage the material (hair cracks and spots on the acrylic surface).