Clearaudio ANNIVERSARY - Handbuch (Seite 5)

Anniversary
User manual / Bedienungsanleitung
Page / Seite 5
 clearaudio electronic GmbH 2008
2. Assembly and Operation
First please put on the white gloves to avoid finger prints on the surface of the
acrylic chassis during installation.
1. Place the chassis on a solid and low resonance base. The base should be levelled
before. To protect the surface of the chosen rack, simply use the delivered flat pads
placing them under the spikes of the turntable chassis.
2. Unpack the turntable platter with the upper part of the platter bearing. Remove
the protective security tape from the bearing housing and place this unit carefully
over the spindle mounted in the turntable chassis. Do not use too much pressure for
this step otherwise you will cause damage to the bearing.
Caution: pay attention not to place any of the grease on the acrylic surface of the
chassis. Be sure that the two markings (platter, upper part of the bearing shown in
pic. 2) are positioned as shown in the figure.
3. Place the pulley on the motor spindle. The distance between the pulley
and the motor housing should be approx. 1-2mm. Tighten the little screws
inside the pulley with the aluminium screwdriver provided (pic. 3).
4. Place the stand alone motor on the top of the motor stand on
the position as shown in the right figure. The power switch on the
upper side of the motor should show to the outside and the pulley
to the turntable platter. The distance between the motor chassis
and the turntable platter should be approximately 2 cm (ca. ½
inch) (pic. 4).
Picture 1: Placing the platter
Picture 2: Markings of the bearing
Picture 3: Pulley on the motor
Picture 4: Placing the motor