Clearaudio NANO PHONO HEADPHONE V2 - Handbuch (Seite 5)

English
Congratulations on the purchase of your new Nano Phono V2 / Nano Phono “H” V2
MC/MM phonostage.
The Nano Phono V2 / Nano Phono “H” V2 features a power switch: we recommend
that you keep the unit switched on in order to maintain a constant temperature for the
electronic parts inside (this uses very little power). The new Nano Phono V2 / Nano
Phono “H” V2 also has a built-in volume control unit.
- Set up -
IMPORTANT!
First, select either the MC (moving coil) or MM (moving magnet) mode according to your
cartridge type, by inserting the removable jumpers into the relevant positions on the bot-
tom of the unit (one each for left and right channels).
The subsonic-filter function can also be adjusted by inserting jumpers into the relevant
points on the bottom of the unit: if the jumper is inserted, then the subsonic filter is
OFF. If the jumper is not inserted, then the subsonic filter is ON.
The next step is to connect the ground wire of the turntable/tonearm with the Nano Pho-
no V2 / Nano Phono “H” V2. Make sure that the gain control is set to its lowest volume
before connecting the Nano Phono V2 / Nano Phono “H” V2 to your MC/MM cartridge
and preamplifier.
Finally, the very last thing to do is to connect the power supply to the mains and press the
power switch to the “ON” position.
- Attention -
Never cover or put anything on top of the Nano
Phono V2 / Nano Phono “H” V2 as this could lead
to overheating of electronic parts.
If the unit a longer time not in use, please press the button on top of the device. If the
device is not in use, disconnect it completely from the power supply by removing the main
plug from the socket.
Standby mode
- Notice -
1. If you are using the Nano Phono V2 / Nano Phono “H” V2 with a two-pin mains plug,
you may notice that inserting the plug into the mains socket one way round gives a slightly
better sound than the other way.
Experiment to identify which is the optimum position.
Seite 4 / page 4