Clearaudio BALANCED REFERENCE PHONOSTAGE - Handbuch (Seite 6)

Balanced Reference Phonostage
(optional. Incl. ACCU / optional: inkl. AKKU
User Manual/ Bedienungsanleitung
Page/Seite 6 Clearaudio electronic GmbH 2013
5. Setting gain and load impedance/capacitance
The Clearaudio “ Balanced Reference Phonostage” provides adjustable total gain from 30 dB to 63
dB in 3 dB steps with a rotary switch. With a push button switch at the rear panel you also can reduce
the gain to 20 dB, for example, when you are using a MM-Cartridge (a MM-Cartridge supplies approx.
20dB more output voltage as a MC-Cartridge). Factory-made the input impedance/capacity is set to 47
kOhms/100 pF for MM-Cartridges, but you can set the input impedance for any cartridge, by using
the 5-pin binder-connector or the socket R101 on the circuit board of both channels. If you use
the binder connector for your tonearm, then take socket R101 to set the input impedance. For the
input capacitance is socket C101 on the circuit board, if you need an other capacitance, you have
to change the condenser at both channels.
6. Safety instructions
Important!
 Use the equipment only if you see no outside damages!
 Don`t recycle the equipment over the domestic refuse!
 Clearaudio takes the equipment back free of charge.
7. Service
In case of any necessary: Service for all Clearaudio products should be done by authorized personal
only.
In case of any repair, the clearaudio equipment needs to be send to your nearest authorized dealer or
directly to Clearaudio: .