Clearaudio ABSOLUTE PHONO - Handbuch (Seite 3)

Absolute Phono
Page / Seite 3
 Clearaudio Electronic GmbH 2014
User manual / Bedienungsanleitung
1. Installation and set-up
Before you begin, make sure that the tonearm is correctly installed on your turntable and is equipped
with the Clearaudio Absolute Phono headshell and Clearaudio Direct Silver Wire with the special 9–
pin connector.
To proceed with installation and set-up, please see the rear panel of your Clearaudio Absolute
Phono.
Rear view:
Please proceed as follows:
1. Connect the special 9-pin connector from the tonearm to the input marked “input amplifier”
and gently secure with the two locking screws. Please make sure that the screws are properly
tightened and thus the plug is securely connected
2. Plug the RCA or XLR cable into the output sockets and connect them to your linestage preamplifier.
3. Connect the power supply provided to the socket marked “DC in”, “6V”, then connect this power
supply to your mains power supply.
4. Connect the power supply to the main power and switch the button to “I”.
Important: Please note that you may only use power supplies with a voltage of 6V DC!
5. Lightly press the multi-function
push-button on the front of the
Absolute Phono. The blue LED
ring will flash approximately
seven times and then glow
steadily.
Your Clearaudio Absolute Phono
is now ready to use and enjoy.
1
.
2
.
2
.
3
.
4
.
Pic.1: Absolute phonostage (rear view)
Pic.2: Absolute phonostage (front view)
4
.
5
.