Clearaudio ABSOLUTE PHONO INSIDE - Handbuch (Seite 3)

Absolute Phono -
inside
Page / Seite 3
 Clearaudio Electronic GmbH 2014
User manual / Bedienungsanleitung
1. Installation and set-up
Before you start, make sure that the tonearm is correctly installed on your turntable.
To proceed with installation and set-up, please see the rear panel of
your Clearaudio Absolute Phono- inside.
Rear view:
Please proceed as follows:
1. Connect the tonearm ground wire to the “GND” terminal.
2. Connect the tonearm to the input marked with “phono in R / phono in L”. You can use either RCA
or XLR inputs.
To avoid hum problems by using the RCA Phono input, please make sure that the RCA or XLR plugs
and the tonearm ground wire are securely connected.
3. Plug the XLR output cable into the XLR output sockets and connect them to your linestage
preamplifier.
4. Connect the power supply provided, to the socket marked “DC in” on the Absolute Phono - inside
main RIAA unit, then connect this power supply to your mains power supply and switch the button on
“I”.
5. With “DIMMER” you can adjust the light intensity of the blue LED-Ring on the front side.
Important: Please note that you should use only the Clearaudio power supply provided.
6. Lightly press the push button on the front of the
Absolute Phono- inside
The blue LED ring will flash approximately seven times and
then glow steadily.
Your Clearaudio Absolute Phono- inside is now ready to
use and enjoy.
4
.
2
.
2
.
3
.
Pic.1: Absolute Phono - inside (rear view)
Pic.2: Absolute Phono – inside ( front view)
1
.
3
.
5
.
6
.
4
.