SUNBOUNCE WIND-KILLER-STATIC - Handbuch

WIND-KILLER STATIC
Aufbauanleitung
Operating Instructions
Stand 2012/03/28
SUNBOUNCE.COM
Operating Instructions
1. The individual parts of the WIND-KILLER STATIC consist of a screen,
two bars (2-piece set), two tensioning cords and four pegs.
2. The rods must first be plugged together.
3. Thread each a pole on the left and right into the sleeves of the screen.
4. Make sure that the tips of the rods look out of the amplified corners at the
upper end of the sleeves.
5. Now pull each rubber which is attached to the D-ring at the other end of
the covering on the case over the tips of the rods. Thus, the covering is being
stretched tautly in a vertical direction.
6. Strip each of the loops, in the middle of the tensioning cords, over the
upper tips of the rods.
7. Now insert the lower end of each rod in the ground and tighten it with
using the stretch lines and the four pegs. Now your WIND-KILLER STATIC is
ready to use.
SUNBOUNCE GmbH · Buchenring 8 - 10 · 21272 Egestorf · Germany
Telefon: +49 (0) 4175 - 80 88 79 87 · Telefax: +49 (0) 4175 - 80 88 79 67
E-Mail: [email protected] · Internet: www.sunbounce.com
© 2013 SUNBOUNCE GmbH. All rights reserved.